Concrete Testing Equipment

This apparatus is used for determination of flash point & fire point of Petroleum products except fuel oil with open flash 80 degree C as per specification IP 36/57, IS 1448 (P:69) 1969 and ASTM-D-92-67.The apparatus consists of a cup heating plate to specific dimensions thermometer clip and test flame attachment with swivel joint for passing over liquid surface in the prescribed manner, heater is controlled by means of Energy regulator/voltage Varric Copper coil type fitted to the apparatus suitable for operation on 220 Volts AC mains. 

Compression Testing Machine Make: Vertex - Digital Hydraulic 200 Tons Capacity, Electrical Cum Hand Operated, Four Piller  Type, Suitable Operation on 415 Volts Three Phase A.C. Supply. With company own Calibration Certificate Valid for Six Months.

• Delivery Time: 4 to 5 days

Wellon High Precision Pen Type pH Meter for Water Purity 0.01 Resolution pH Tester with Calibration Powder and Carry Case.

25mm dia Needle with 2 H.P. Electric Motor.

Make:- Bosch Modal:- DNM 60L Professional 1200mm length,Angles in 0 degree, % and bubble,2 vials,Measuring range 0 to 360 degree (4 x 90).Measuring accuracy =/-02 d eg,  Electronic,measuring accuracy 0 to 90 degrees +/- 0.05deg,Battery life 200hrs approx,Auto shutdown 5 minutes,Battery supplied, Weight 0.7kg,Shoulder bag,Size w x h x l 25mm    x60mm x 600mm, Technical Data,Length  120 cm,Measurement range  0 - 360° (4 x 90°).Electronics measurement accuracy 0°/90°  +/- 0.05°,Electronics measurement accuracy at 1°-89°  ± 0.2°. Measurement accuracy, vials  +/- 0.057°,  +/- 1 mm/m,Power supply  1 x 9 V 6LR61.Operating duration, approx.  200 h,Automatic deactivation facility, approx.  5 mins,Weight approx.  0.7 kg,Width  25 mm,Height  60 mm

BENCH TOP TENSILE TESTING MACHINE

A small-scale machine that fits on a benchtop and allows simple tensile tests of metal specimens up to a maximum load of 20 kN. This machine is a good partner to TecQuipment's Torsion Testing Machine (SM1001). The machine has an extruded aluminium bed that holds the load application and load measuring mechanisms. 'Tie bars' add rigidity to the structure. 

The load application mechanism includes a hand-driven worm-and-wheel gearbox, driving a lead screw with approximately 400 mm of travel. The mechanism uses ball races and self-aligning ball thrust races in the direction of loading. These low-friction bearings, with the large handwheel allow the user to apply maximum load with minimum effort. They also give smooth and progressive operation, necessary to help the user apply a steady strain rate for best results. 

The unit also has a smaller "quick advance" handwheel that allows the user to set the distance between the chucks simply and quickly before each test. 

100 and 200  mm long